The corresponding guide at the top allows the shaper to take incremental measurements of a designįt - cm - mm - ft (decimal) - Ft / mm Keysįt-cm-mm-ft (decimal)-ft/mm Keys: These keys are used to toggle between different units of measurements How to use the N Rocker - T Rocker Tool 1:1 Ratio Toolġ:1 Ratio Tool: Used an alternative, zoomed out design perspective. *Use the Up and Down arrow keys to control the movement of the rocker N Rocker: Move the entire Nose rocker up or down using in the Top/Bottom tab T Rocker: Move the entire Tail rocker up or down using this key in the Top/Bottom tab To manually enter points, use the Guide Points tab in the tool bar. To add points, use the Add Guide key in the tool bar. Or to make marks along an outline to plot out a new shape. Undo - Redo Keys: Use the back and forward keys to undo a change or redo a change Add GuideĪdd Guide: Guide points are added to use a reference point from an existing shape.
Points can be added in the Outline, Slices, Top, and Bottom tabs *Tip: Zoom In & Place control points close together to create wings, beak noses, and channels. Points must be added at the bottom outline of the design. Zoom Fit: Revert back to full view from the zoom position Add PointĪdd Point: Add additional control points using this key. Zoom Box: Draw a square around the area you want to zoom to work in a closer proximity Startup Guide on How to use AkuShaper toolbar keys Zoom Box
